Mmsi Code Programming - Oricom MX1100G Instruction Manual

■

■ MMSI Code Programming

The 9-digit MMSI (Maritime Mobile Service Identity: DSC self ID) code can be pro-
grammed by PC software and also manually set on this radio.
1. Press and hold [PWR] knob to power ON.
• Three short beeps sound, and "Push [OK] to Register your MMSI" is dis-
played.
2. Press [OK] to start setting the MMSI code.
• During the setup process, press [BACK] to skip the setting and return to
normal operating mode, and you cannot make a DSC call.
3. Enter the MMSI code:
• Press [◄]/[►] to select the desired number.
• Press [OK] to input the selected number.
• Select "←" or "→", or rotate [DIAL] to move the cursor, then press [OK].
4. Repeat step 3 to enter all 9 digits.
5. After 9 digits have been input, press softkey [
6. Enter MMSI code again to confirm.
14
DSC OPERATION
7. Repeat step 3 to 5 as above.
NOTE: In the menu interface, you can query the set MMSI code.
■ ATIS ID Programming
The Automatic Transmitter Identification System (ATIS) ID consists of 10 digits. You
can enter the ATIS ID in the "ATIS ID Input" item on the Menu screen.
Entering the ATIS ID can only be done once via the radio, once entered it can only
be changed via PC programming software.
1. Press [MENU] key, the menu interface is displayed.
2. Press [▲]/[▼] or rotate [DIAL] knob to select "ATIS Setting", then select "ATIS
] to set the code.
3. Enter the ATIS ID:
• When your MMSI code input is successful, "MMSI Successfully Registered"
is displayed as below.
• Once setup is complete the radio can now perform normal operation.
■
ID Input", then press [OK], the "ATIS ID Input" screen is displayed.
• Press [◄]/[►] to select the desired number.
• Press [OK] to input the selected number.
• Select "←" or "→" to move the cursor, then press [OK].