Dsc Address Id - Oricom MX1100G Instruction Manual

4. Repeat step 3 to enter all 10 digits.
5. After 10 digits have been entered, press softkey [
6. Enter ATIS ID again to confirm.
7. Repeat step 3 to 5 as above.
• Once setup is complete the radio can now perform normal operation.
NOTE: In the menu item "Radio Info", you can query the set ATIS ID.
■

■ DSC Address ID

Before using the DSC call related function, the DSC can be set as follows:
1. Press [MENU] key, the menu interface is displayed.
2. Press [▲]/[▼] or rotate [DIAL] knob to select "DSC Settings".
3. Press [OK], the "DSC SETTINGS" screen is displayed.
4. Press [▲]/[▼] or rotate [DIAL] knob to select the submenu item you want to
set up.
• The setting items includes Position Input, Individual ID, Gourp ID, Auto ACK,
CH Auto SW, Data Output, Alarm Status, CH 70 SQL Level, Self-Test, Mul-
ti-Task.
5. Press [OK] to enter next level menu.
6. Press [BACK] or softkey [
] to return to main interface.
softkey [
] to set the ID.
] to return to the previous menu. Press
■
◆ Entering the Position and Time
A Distress call should include the vessel's position and time. If no GPS data is re-
ceived, manually input the position and Universal Time Coordinated (UTC) time.
• The manual entry is disabled while valid GPS data is received.
• The manually entered position and time is valid only for 23.5 hours, or until turning
OFF the radio.
1. Display the "POSITION INPUT" screen.
2. Press [▲]/[▼]/[◄]/[►] to enter longitude and latitude.
• Press [◄]/[►] to select desired number.
• Press [OK] to enter.
• Select "←" or "→", or rotate [DIAL] to move the cursor, then press [OK].
• Move cursor to "N" or "S" to select N (North Latitude) or S (South Latitude).
• Move cursor to "W" or "E" to select W (West Longitude) or E (East Longitude).
3. After position is entered, press [OK] to confirm.
4. In the UTC time editing interface, enter the UTC time as follows.
• Press [◄]/[►] to select desired number.
• Press [OK] to enter.
• Select "←" or "→", or rotate [DIAL] to move the cursor, then press [OK].
5. Press softkey [ ] to confirm position and time setting.
6. Press softkey [ ] to return to standby interface.
• The entered position and time are displayed on the operating screen.
15