Introduction; Symbol Meanings; Important Shipping Information; Tools Typically Required - EZ-ACCESS PATHWAY Assembly Manual

INTRODUCTION

The PATHWAY® Modular Access System includes Low Profile Platforms which are only 1-9/16" thick (tall) as
compared to standard platforms which are approximately 3-1/2" thick (tall). Throughout this document, the
PATHWAY® Low Profile Platform may also be referred to as the Low Profile Platform, or Platform.
ATTENTION INSTALLER and END USER
• For residential use only!
• 850 lb. Rated Load. Never exceed Rated Load.
• Read all instructions and follow all labels, instructions, and WARNINGS prior to assembly and use.
• For copies of complete instructions, WARNINGS, or for additional care, use, or safety information, call
customer service at 1-800-451-1903.
• Please leave this document with the end user.

SYMBOL MEANINGS

The WARNING symbol indicates a potentially hazardous condition/situation. The safety warnings
throughout this manual, and on your equipment, if any, are for the protection of people and property.
Failure by any operator to abide by safety warnings will result in a waiver of all liabilities, loss of your
warranty, and could result in equipment damage and or failure, property damage, risk of serious bodily
injury, and or death. The symbol may appear in various colors and in conjunction with other symbols and
with or without the written word "WARNING".
The NOTE symbol indicates important information. Failure to obey all notes could result in improper
operation, less-than-optimum equipment performance, and at the sole discretion of the equipment
manufacturer, may void your warranty. The symbol may appear in various colors and in conjunction with
other symbols and with or without the written word "NOTE".

IMPORTANT SHIPPING INFORMATION

Immediately open shipping boxes and inspect for damage or missing parts. If damaged or missing parts are
noted, DO NOT INSTALL OR USE.
Each system is shipped with a packing list. Confirm all items are present before starting installation. Also
check for shipping damage immediately upon receipt and note any freight damage on freight bill while
driver is still present. Contact shipper right away with any freight damage concerns. In most cases, freight
damage claims will not be allowed unless noted on the freight bill. Pictures of damage before the unit is
unpacked can be very helpful.

TOOLS TYPICALLY REQUIRED


POWER DRILL
 1/8"
DRILL BIT
 1/2" 1/2"
SOCKET OR

RUBBER MALLET

BOX KNIFE

HAMMER
 25'
TAPE MEASURE

LEVEL

FILE
#2

5/16"

9/16"

WRENCH
1/4"

5/32"

3/16"


HACKSAW

DIGGING TOOLS

TWO ABLE
PHILLIPS HEAD SCREW DRIVER
(
DRILL BIT IF BRACE ASSEMBLIES ARE USED
9/16"
SOCKET OR WRENCH
(
MASONRY DRILL BIT USED WHEN INSTALLING TO CONCRETE
(
ALLEN WRENCH INCLUDED
(
ALLEN WRENCH INCLUDED
(
FOR OPTIONAL HANDRAIL KITS
(
IF AN OBSTACLE NEEDS TO BE REMOVED
-
BODIED PERSONS NEEDED FOR INSTALLATION
- 2 -
)
)
)
)
)
)