Advertisement
Use & Cleaning
1. The unit must be securely grounded during operation.
2. Do not cover the unit with anything during operation or a short time after it's shut down.
3. Do not wrap the power supply cord around the unit.
4. Do not use this heater with a separate programmer, timer or any other device that switches the heater on
automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
5. The head of the unit is at high temperature during operation. Unplug the unit and wait till it's cool before cleaning.
6. Do not immerse this unit into water for cleaning.
7. The unit must be handled and transported with care, avoiding risk of impact or vibration in transit.
8. If damaged, the unit must be repaired by a professional repair team.
Assembly Instructions
Preparation:
1. Read this instruction manual carefully before installation and use. Keep the
manual in a safe place for future use in case needed.
2. Unpack the carton. Take out the accessories pack from the carton. Make
sure the accessories listed opposite are included. If anything is missing,
contact the retailer immediately and they will provide you with
replacements.
3. You will need the following tools: pencil, screwdriver, cross-head spanner
suitable for M6 screw nut, steel tape measure, power drill and drill bits.
Installation:
The Apex is suitable for wall or ceiling mounting. The instructions below
apply to both types of installation.
IMPORTANT: The heater must be installed at least 1.8m from the ground and at least 50cm from
adjacent surfaces. If ceiling mounted, the heater should be at least 50cm from adjacent walls; if wall mounted,
the heater should be at least 50cm from the ceiling and adjacent walls. If wall mounted, the heater must be
orientated so it is horizontally level with the control panel on the left. In all cases, the heater must be positioned at
a height where it cannot be touched during operation.
1. Drill four holes in the wall or ceiling for the mounting plate, as per the measurements shown in Fig. A.
2. Insert the four Expansion Bolts into the holes. Use a spanner to twist the Screw Nuts on the Expansion Bolts
clockwise until they are securely located in the holes. Unscrew the Screw Nuts and put them aside with the
Washers and Spring Washers for use later.
3. Place the mounting plate on the ceiling or wall, letting the four expansion bolts go through the holes on the
bracket. Fix in place with Washers, Spring Washers and Screw Nut mentioned above. See Fig. B and Fig. C.
4. Line up the Upper Bracket with the Lower Bracket (already secured to the heater). Thread the Screw M8*70
through the holes and screw tightly, using the M8 nut, as per Fig. C.
5. Mount the heater onto the wall or ceiling by sliding the Upper Bracket into the opening on the Mounting Plate. Fix
in place with the two Screw Knobs M6*12.
6. To adjust the angle of the heater, use a screwdriver to unscrew the Screw M8*70 a little. Set the heater to the
desired angle and drive the Screw M8*70 tight again. The adjustable angle is 60° in total: 30° up, 30° down. See
Fig. D.
PART NAME
Mounting Plate
Upper Bracket
Expansion Bolt M6*70
Screw M8*70
M8 Nut with cover
Screw Knob M6*12
Qty
1
1
4
1
1
2
Advertisement
