hatch X-RAY FS04 Installation And Troubleshooting Manual page 27

5.11 Base Unit Cover Installations
•
Slide and install the side cap to the base unit cover as shown in Figure 56 for two stud mounting. Refer to Figure 57
for single stud mounting configurations.
•
Take the base unit cover along with console and connect the console cable to the J5 connector on the "Console
extension PCB-Internal" located beside the power board as shown in Figure 58.
Horizontal Side Cap
Figure 56
•
Route the exposure switch cable through the slot provided on the base unit cover as shown in Figure 59
•
Refer to Figure 60 and using a 3 mm Allen key secure the base unit cover with 2 screws ( M4x12 Hex socket head
cap).
•
Install the console on the slot provided on the base unit.
•
Replace the cap at the top side of the base unit back to the Extension-arm shaft as shown in the Figure 61.
Exposure Switch cable Routing
Figure 59
5.12 Scissor Arm Operation Testing
Move the Scissor arm and ensure there is no drift as per steps given below.
•
Keep the Vertical Arm in vertical position and horizontal arm in horizontal position.
•
Move the horizontal arm down (folding movement) in small jerk free incremental steps of approximately 10
degrees.
•
At each step as above, leave the scissor arm and ensure that there is no drift movement. Continue till the
horizontal arm reaches vertical position.
•
Keep the Vertical Arm vertical and horizontal arm horizontal position.
•
Pull the L Arm in small jerk free incremental steps of approximately 10 degrees so that the horizontal arm stays
horizontal always and the Vertical arm moves down.
•
At each step as above, leave the scissor arm and ensure that there is no drift movement. Continue till the maximum
expanded position of the scissor arm is reached.
•
Keep the Scissor arm in folded position.
Vertical Side Cap
Figure 57
2 screws (M4 x 12 HSHC using 3mm allen key)
Figure 60
Page 27 of 34
J5 Connector
Figure 58
Placing Cap at the top side of the Base Unit
Figure 61
•