Table of Contents
Advertisement
5.2.3
Base Unit Mounting with Optional Wall Plate (Applicable only for Two Stud Mounting)
Note:
Optional wall plate can be used for ease of input cables routing if hole on the wall is not at the required location
•
Locate the 2 wood studs (2" x 4" studs) to mount the additional wall plate.
•
Mark template holes and drill 5/32" diameter holes to depth of 3½" as shown in Figure 23.
•
Drill the direct wiring hole ( >1.5"diameter).
•
Install power and control wiring, following all local codes for electrical work
•
Remove the four rubber plugs from the corner screw holes of the wall plate and set aside for reuse.
•
If the external console is used, route the input wires and communication cables through the hole provided for
wiring.
•
Secure the plate onto the wood wall studs by using 4 Lag bolts (M10×80) along with M10 plain washers at the
drilled locations using 17mm Box spanner (Do not tighten fully) as shown in Figure 24 .
•
Check and confirm the level using spirit level and then tighten the bolts.
•
Install the four rubber plugs to the corner screw holes of the wall plate.
•
Take the base unit assembly and disconnect the RJ-25(6P6C) cable from the J4 connector on the power board and
disconnect the line & neutral wires from J5 connector on the power board using screw driver as shown in Figure 25
•
Remove1 screw (M3x6 Hex socket head cap) with plain washer used for locking the power board using 2.5mm
Allen key as shown in Figure 26 and swing the power board assembly.
•
Remove the base unit cover clamp by removing 2 screws (M3x6 Hex socket head cap) using 2.5mm Allen key
as shown in Figure 27.
•
Install the base unit plate assembly on the optional wall plate with 6 bolts (M10x20 Hex head) along with M10
plain and spring washers using 17mm box spanner as shown in Figure 28.
Page 14 of 34
.
Advertisement
Table of Contents
