Table of Contents
Advertisement
Connect back the RJ-25(6P6C) cable to the J4 connector and line & neutral wires coming from switch to the J5
•
connector on the power board using screw driver as shown in Figure- 37.
Remove the cable clamp(located near the input wiring hole) by removing 2 screws (M3x6 Hex socket head
•
cap) using 2.5 mm Allen key as shown in Figure- 38.
Using screw driver fix the line and neutral wires coming from behind the Power board to the terminal block
•
such that Line wire matches with label "L", Neutral wire matches with label "N" as shown in Figure- 39.
•
Fix the Earth wire on the power board plate near earthing label with screw(M3x6 Hex socket head cap)using
2.5 mm Allen key as shown in Figure- 39.
•
Fix back the cable clamp routing the input cable through the clamp with 2 screws(M3x6 Hex socket head cap)
using 2.5 mm Allen key as shown in Figure- 39.
Figure- 37
5.5
Extension Arm Installation (For All Variants)
•
Remove the M6 stopper screw from the Extension arm guide rod using 5mm Allen key as shown in Figure 40 .
•
Refer to Figure 41 and loosen the 2 no's of M4x20 Hex socket head cap screws of the bearing block using a 3mm
Allen key.
•
Route the guidewire and ground wire through the slot of the bearing block and mount the Extension arm on the base
unit bearing block and install the M6 stopper screw to the Extension arm guide rod using 5mm Allen key as
shown in Figure 42.
•
Check and confirm the level of the extension-arm using spirit level by rotating the arm to all directions.
Figure 40
•
Tighten the 2 no's of M4x20 Hex socket head cap screws at the location shown in Figure 43 using 3mm Allen key
ensuring the smooth movement of the Extension arm.
•
Route the grounding wire of the Extension arm on the rear side of the power board assembly and fix it at the
grounding label location on the power board plate using 2.5mm allen key as shown in Figure 39 .
Figure- 38
Figure 41
Page 17 of 34
Figure- 39
Figure 42
Advertisement
Table of Contents
