Table of Contents
Advertisement
5.1 Unpacking
•
HATCH X-RAY is shipped in a corrugated box with each sub assembly packed in designated location
positioned by foams.
•
Unpack the X-ray system and inspect each component for physical damage such as scratched panels, damaged
connectors etc. In case of any damages observed, appropriate action has to be taken to get the replacement parts
before starting the Installation. Open the box by cutting the straps and keep all the parts outside on a cushioned
surface as shown in Figure 5 .
•
Pull out the
console assembly from the base unit cover and remove 2 Screws (M4x12 Hex socket head cap) using
3 mm Allen key as shown in Figure 6 .
•
Lift the base unit cover slowly and disconnect the Console cable (if connected) from J5 connector of Console
extension board-internal located beside the power board as shown in Figure 7 and keep it separately.
5.2 Base Unit Mounting
•
HATCH X-RAY Wall mount Unit comes packed in Single stud mounting configuration. In order to convert the unit for
Two stud installation configurations follow the procedure provided below.
Page 11 of 34
Advertisement
Table of Contents
