Operation; Initial And New Installation - IMKO SONO-View Manual

4 Operation

4.1 Initial and New Installation

At the initial connection to your probe-network, it is necessary to set the same up, respectively follow an
installation procedure at the SONO-VIEW.
8
For this purpose, the device will scan the IMB bus for
connected probes.
Initiate the installation with the button
After an instant, the serial numbers of all connected
probes are listed in the display.
In order to maintain the clarity within the administration
of the probes, the SONO-VIEW operates on the basis
of assigned probe numbers (1...4).
These must be allocated to the detected serial numbers
in the next step. For each probe number, select a serial
number using the
acknowledge the same with the button
Repeat this procedure until all serial numbers have
been allocated a probe number.
After completion of the above steps, all probe numbers
will be presented once more together with the
respectively allocated serial numbers in ascending
order.
Complete the installation process with the button
.
/ buttons and subsequently
.
.