IMKO SONO-View Manual page 25

Danger by electricity
The hand-held meter must not be immersed in water or other liquids. The sensor is
insensitive to moisture contained in the typically measured products. Only connect
the hand-held meter to a properly installed outlet with the supplied voltage supply
cable, the voltage of which corresponds to the technical data. Make sure that the
power outlet is well accessible, so that you can unplug the power supply quickly if
necessary. Use only the adapter that is suitable for your outlet.
Only operate the meter with the supplied original accessories. If you need additional accessories or
replacement, please contact the manufacturer.
Do not use the meter in following case:
•
if the measuring instrument, sensor, plug-in power supply or accessories are damaged,
•
the sensor or the measuring system does not operate as intended,
•
the power cord or plug is damaged,
•
the sensor or the measuring system has fallen down.
Unplug the power supply from the wall outlet in following case:
•
if you do not use the sensor or the measuring system for an extended period of time,
•
before cleaning, unpacking or changing the sensor or the measuring system,
•
if you are working inside the sensor or measuring instrument, e.g. connect devices,
•
if a fault occurs during operation,
•
during thunderstorms.
Caution - Property damage
Ensure that there is a sufficient distance to strong heat sources such as heating plates,
heating pipes. Disconnect the sensor or handheld device from other devices before
relocating or transporting it. Disconnect the connectors on the device.
Do not use aggressive chemical cleaning agents, scouring agents, hard sponges or the like.
25