Table of Contents
Advertisement
9. TOTALIZE=XXX (SCALE TOTALIZER)
With the 225-DS (Dual Scale) Card installed and the number of scales set for 2 or 3, the 225
can sum the weights of two or more scales and make the total available to be displayed.
The totalizer can be referenced as if it were another scale. NOTE! The totalizer's scale
number will always be 4 regardless of the actual number of scales attached to the indicator.
With SETUP MENU #1 displayed the current setting for the TOTALIZE= parameter
will be shown. Note that XXX is the current value. If the setting displayed is acceptable,
proceed to the next setup parameter.
Otherwise, press the 9 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to SETUP MENU #1.
10. MODE OF OP=X
IMPORTANT! The Mode Of Op is limited to options 0. NORM (Normal Indicator),
1. IDS (ID Storage) or 3. Preset Weight Comp (Preset Weight Comp).
Refer to the 225 Weight indicator Installation and Technical Manual, 8200-M538-O1, for
information and instructions on Mode of Operation.
SETUP MENU #2
With SETUP MENU #1 displayed, press NEXT (Navigation Keys Down Arrow) to
proceed to SETUP MENU #2.
1. SERIAL
2. DIO
3. PRINT TABS
4. SETUP SCALE 1
5. CALIBRATE 1
Enter Selection: 0
Parameters 8 and 9 will only be shown if 3 has been entered for the number of scales.
IMPORTANT! If YES was selected for the TOTALIZE parameter (refer to SETUP
MENU #1), then the following parameter will be shown on SETUP MENU #2.
INDICATOR SETUP, CONT.
XXXX (MODE OF OPERATION)
SETUP MENU #2
10. TOT CAP=XXXXXXX
8200-M535-O1 Rev B 225-DS
6. SETUP SCALE 2
7. CALIBRATE 2
8. SETUP SCALE 3
9. CALIBRATE 3
`
NEXT
^
PREV
12
Advertisement
Table of Contents
