Related Manuals for Cardinal VET330
Summary of Contents for Cardinal VET330
- Page 1 MODEL VET330 DIGITAL VETERINARY SCALE Operation Manual CARDINAL SCALE MFG. CO. 1961-M045-O1 Rev A Printed in USA PO BOX 151 WEBB CITY, MO 64870 10/05 PH (417) 673-4631 FAX (417) 673-5001 www.detectoscale.com...
-
Page 3: Table Of Contents
Thank you for purchasing our Detecto Model Introduction ………………………………….. 1 VET330 Digital Veterinary Scale. The Specifications.………….………….………… 1 VET330 is equipped with a rechargeable Installation………………………………….… 2 battery pack that (after 14 hours of charging) is able to provide approximate 8 hours of Display Functions ……..……..…..…………. -
Page 4: Installation
It will take approximately 14 hours to fully recharge the battery pack in the scale. While the batteries are charging the VET330 can still be operated. Note that charging the battery pack for more than 14 hours will not damage it. -
Page 5: Display Functions
DISPLAY FUNCTIONS The display functions are turned on to indicate that the scale display is in the mode corresponding to the function label or that the status indicated by the label is active. This is turned on when the weight display is stable. This is turned on when a negative (minus) weight is displayed. -
Page 6: Key Functions
KEY FUNCTIONS HOLD 1. Press HOLD key, the arrow in the left bottom flashes. When the loaded weight is above 3.3 lb /1.5 kg and stable, the arrow stops flashing. 2. To disable the hold function, press HOLD key again, and the arrow disappears. 3. -
Page 7: Operation
OPERATION TURN THE SCALE ON Press the ON / ZERO / OFF key to turn the scale on. The scale will display then change to the selected weighing units. 88888 SELECT THE WEIGHING UNIT Press the UNIT key to alternate between the selected weighing units. NOTE! Multiple weighing units must be enabled during configuration for this function to be operational. -
Page 8: Configuration
CONFIGURATION The Scale has been pre-configured at the factory and should not require configuration for use in most applications. In the event that the factory settings do not meet the requirements of your application, the following describes the steps to configure the scale. TO BEGIN CONFIGURATION: 1. -
Page 9: Gravity Compensation
CONFIGURATION, Cont. GRAVITY COMPENSATION 1. With the display showing Oaf , press the press UNIT key 4 times. The display will change to show GRAU . 2. Press the HOLD key. To Enable the Gravity Compensation mode, press the UNIT key. The display will change to On . -
Page 10: Display Message
DISPLAY MESSAGES DISPLAY MEANING Low battery indication prom Error ErrE Zero count too low ErrL Over Load / Zero count too high CARE AND MAINTENANCE The heart of the PS-7 Digital Portion Scale is a precision load cell located in the center of the scale base.
Need help?
Do you have a question about the VET330 and is the answer not in the manual?
Questions and answers