Table of Contents
Advertisement
6. Next, referring to Figures No. 2 and 3,
locate the 6-32 threaded stud in the
lower right corner of the enclosure
securing the main board. NOTE! This is
where the ground wire from the 225-DS
will be connected.
7. To attach the ground wire, remove the
6-32 nut and washer and then place the
ring terminal from the 225-DS ground
wire over the 6-32 threaded stud.
Reinstall the washer and 6-32 nut and
tighten. Refer to Figure No. 3.
NOTE! Position the ring terminal with
the wire extending away from the main
board as shown to prevent shorting.
8. To install the Dual Scale Input Card,
carefully align the dual row of pins on
the top of the 225-DS card (on the trace
side of the card) with connector P2 on
the main board and apply even
downward pressure to the edge of the
225-DS. See Figure No. 4.
INSTALLATION, CONT.
Figure No. 2
8200-M535-O1 Rev B 225-DS
Connector
P2
Figure No. 3
Figure No. 4
Threaded
Mounting
Spacers
6-32
Threaded
Stud
6-32
Threaded
Stud
225-DS
Ground
Wire
Align pins
with holes
in P2
4
Advertisement
Table of Contents
