Emerson CF766LBQ00 Owner's Manual page 8

3. Ceiling Fan Assembly
3.9
While pulling up on the 8" Downrod, reinstall the two
Set Screws (previously removed) in the Motor Coupler
to secure the Downrod into place (Figure 9).
NOTE: The Set Screws must be properly installed
as described above, or fan wobble could result.
WARNING
!
It is critical that the set screws are securely tightened.
Failure to verify that the set screws are properly
installed could result in the fan falling.
3.10
Make sure the Grommet is properly installed in the
Coupler Cover, then slide the Coupler Cover on the
Downrod until it rests on the Motor Housing (Figure 10).
3.11
Place the Ceiling Cover over the Downrod.
Be sure both the Ceiling Cover and the Coupling Cover
are oriented correctly (Figure 11).
(Continued)
MOTOR COUPLER
Figure 9
DOWNROD
Figure 10
DOWNROD
CEILING
COVER
Figure 11
8
DOWNROD
REINSTALL
SET SCREWS (2)
GROMMET
COUPLER COVER
ETL Model No.: CF766L