Emerson CF766LBQ00 Owner's Manual page 9

3. Ceiling Fan Assembly
3.12
NOTE: Only use the Hanger Ball supplied with this
Ceiling Fan.
Route the three 80" Motor Leads through the Hanger
Ball.
Reinstall the Hanger Ball (Figure 12) on the Downrod
as follows:
Position the Hanger Ball Pin through the two holes in
the Downrod and align the Ball so the Pin is captured in
the Groove in the top of the Hanger Ball.
Pull the Hanger Ball up tight against the Pin and
securely tighten the Set Screw in the Hanger Ball.
NOTE: A loose Set Screw could create fan wobble.
3.13
The Fan comes with Black, Blue and White Leads that
are 80" long.
Measure up approximately 6 to 9-inches above top of
Hanger Ball / Downrod Assembly (Figure 13).
Cut off excess Leads and strip back insulation 1/2-inch
from end of Leads.
You have now completed the initial assembly of your
new Ceiling Fan. You can now proceed with hanging
and wiring your Fan.
Please call Emerson
1-800-654-3545 if you have any questions about
installation and operation of this Ceiling Fan.
technical support at
(Continued)
PIN
HANGER BALL
DOWNROD
Figure 12
1/2-INCH
6 TO 9
INCHES
Figure 13
9
Please contact 1-800-654-3545 for further assistance
BLUE WIRE
BLACK WIRE
WHITE WIRE
HANGER BALL
emersonfans.com
ETL Model No.: CF766L