Cutting Angle Adjustment; The Base; The Operation Cycle - Promac SX-823DGSVI Manual

When cutting angles, it may require the adjustment
of the vise jaw's position so that the saw blade's
path is not impeded. Follow the procedures below.
- Release the track support by turning handle (1)
counter-clockwise.
- Release the vise by moving the lever (2) to the
left.
- The vise may now be moved to right position or
left position by pushing with one hand on the
adjustable vise jaw and the other hand on the
track handle (1).
- Once in position, move the lever (2) to the right to
lock it into position. If the lever (2) is not between
the vise/bed mounts and facing the user, then the
vise will not be able to lock. If the vise lever (2)
has gone beyond or is obstructed by a vise/bed
mount, then use the following procedures.
- Adjust the lever (2) by grasping at the pivot point
(P) and lowering it, which may assist in the
adjustment. The lever can now be freely rotated
into a more convenient position. Some
movement of the vise jaw may be required. Raise
the lever (2) then move to the right to lock.
- Lock the track support (1) by turning handle
clockwise.

3.4 Cutting angle adjustment

Cutting at angles
Angle can be cut up to 60
-
Unlock lever (L) by pushing it to the left side.
-
Rotate the saw arm to the desired angle by
-
following the index on the scale.
Lock lever (L) by pushing to the right side.
-

3.5 The base

- A structure supporting the SAW ARM (revolving
arm for gradual cutting and respective blocking
system), the VISE, the BAR STOP, the ROLLER for
the support of the material. The base houses the
cooling liquid TANK, PUMP, and the DEVICE
CONTROLLING THE AUTOMATIC HYDRAULIC
LOWERING AND RISING OF THE SAW FRAME.
L
o
SX-823DGSVI
The main connect switch is designed with a lock
hole. A lock can be attached to the lock hole to
prevent machine operation for safety and security
purposes.
- To use the footpad switch (J), first use the side of
the foot to push aside the plastic clip that blocks
the foot pad. Be careful not to damage the clip by
using excessive force or stomping on the footpad.
Next, step down on the footpad to start operation.

3.6 The operation cycle

- Make sure the voltage indicated on machine motor
is the same as power source voltage. Connect
the machine to the power source, and Press the
main connect switch (B). If power indicator light
(1) is on, it means the voltages are okay.
*Note: While selecting the cutting speed indicator
light will blink.
-Press hydraulic flow control start switch (G). *Note:
If the hydraulic flow control fails to activate, then
switch (C), (D), and (F) cannot operate. Indicator
light (7) will blink if any are pressed, indicating that
start switch (G) has failed to activate.
-Check the hydraulic oil level. If oil rises up, it
means the motor is running in the right direction.
If not, rewire the plug.
- Check that the saw arm is properly set. Press
saw bow switches (C) or (D) to adjust the bow
height to help when setting the workpiece.
-Place the workpiece in the vise and clamp
securely.
-Select the speed using speed selector switch (K).
-Be sure to stand in a safe location while operating.
There are two ways to start the machine. Press
the switch (C) to let the saw bow return to the
- 5 -
SX-827DGSVI
J