Accident Prevention And Safety Regulation; Advice For The Operator; The Electrical Equipment According To European; Standard" Cenelec En 60204-1 - Promac SX-823DGSVI Manual

1 ACCIDENT PREVENTION AND
SAFETY REGULATION
This machine has been designed to comply with
national and community accident-prevention
regulations. Improper use and/or tampering with the
safety devices will relieve the manufacturer of all
responsibility.

1.1 Advice for the operator

- Check that the voltage indicated on machine
motor is the same as the line voltage.
- Check the efficiency of your electric supply and
grounding system; connect the power cable of the
machine to the socket and the ground lead
(yellow-green in color) to the grounding system.
- When the saw frame is in suspended mode (or
raised) the blade must not move.
- Only the blade section used for cutting must be
kept unprotected. To remove guards operate on
the adjustable head.
- It is forbidden to use the machine without its
shields
- Always disconnect the machine from the power
socket before blade change or carrying out any
maintenance job, even in the case of abnormal
machine operation.
- Always wear suitable eye protection.
- Never put your hands or arms into the cutting area
while the machine is operating.
- Do not shift the machine while it is cutting.
- Do not wear loose clothing like: shirts with sleeves
that are too long, gloves that are too big, bracelets,
chains or any other object that could get caught in
the machine during operation. Tie back long hair.
- Keep the area free of equipment, tools, or any
other object.
- Perform only one operation at a time. Never
have several objects in your hands at the same
time. Keep your hands as clean as possible.
- All internal operations, maintenance or repairs,
must be performed in a well-lit area or where there
is sufficient light from extra sources so as to avoid
the risk of even slight accidents
1.2 The electrical equipment according to
European Standard" CENELEC EN 60204-1"
- The electrical equipment ensures protection
against electric shock as a result of direct or
indirect contact. The active parts of this
equipment are housed in a box to which access is
limited by screws that can only be removed with a
special tool; the parts are fed with alternating
current as low voltage (24V). The equipment is
protected against splashes of water and dust.
- Protection of the system against short circuits is
ensured by means of rapid fuses and grounding;
in the event of a motor overload, protection is
provided by a thermal probe.
- In the event of a power cut, the specific start-up
button must be reset.
- The machine has been tested in conformity with
point 20 of EN 60204
1.3 Emergencies according to European
Standard "CENELEC EN 60204-1"
- In the event of incorrect operation or of danger
conditions, the machine may be stopped
immediately by pressing the red mushroom
button.
- The casual or voluntary removal of the blade
cover of the flywheels causes the stepping-in of a
interlock switch that automatically stops all
machine functions.
- In case blade breakage, the tension release micro
switch disconnects all machine functions.
NOTE: Resetting of machine operation after each
emergency stop requires specific restart button.

2 MACHINE DIMENSIONS

TRANSPORT INSTALLATION
DISMANTLING
2.1 Machine dimensions
SX-823DGSVI

2.2 Assembling the control box to the saw

- Attach the control box to the saw with two
provided set screws.
- 2 -
SX-827DGSVI