The Gearbox; Special Maintenance; Technical Characteristics; Table Of Cutting Capacity And Technical Details - Promac SX-823DGSVI Manual

6.9 The gearbox

R, S
The gear box requires periodic changing of oil.
The oil must be changed by the first 6 months of a
new machine and every year thereafter.
To change the gear box oil
- Disconnect the machine from the power
source.
- Raise the saw arm to vertical position
- Release the drain hold (R) to draw off gear oil
by loosening the hex socket screw (S).
- Replace the screw (S) after oil completely flows
off.
- Place the saw arm back to horizontal position.
-
Fill Gear box with approximately .3 liter of gear
oil through the hole of the vent screw (Q)
For reference, use SHELL type gear oil or Mobile
gear oil #90.

6.10 Special maintenance

Special maintenance must be conducted by skilled
personnel. We advise contacting your nearest
dealer and/or importer. Also the reset of protective
and safety equipment and devices (of the reducer),
the motor, the motor pump, and other electrical
components requires special maintenance.

7 TECHNICAL CHARACTERISTICS

7.1 Table of cutting capacity and technical
details
SX-823DGSVI
Q
- 11 -