Table of Contents
Advertisement
Available languages
Available languages
2.3 Machine Transportation
To move the machine,
use a forklift truck or sling it with straps as
illustrated.
2.4 Minimum requirements for housing the
machine
- Main voltage and frequency must comply with the
machine's motor requirements.
- Environment temperature should fall within –10 ºC
to +50 ºC.
- Relative humidity cannot be over 90%.
2.5 Anchoring the machine
Position the machine on a firm cement floor,
maintaining, at the rear, a minimum distance of 800
mm from the wall; anchor it to the ground as shown
in the diagram, using screws and expansion plugs
or tie rods sunk In cement, ensuring that it is sitting
level.
2.6 Instructions for assembly of the loose parts
and accessories
Fit the components supplied:
Detail 1 Mount bar-stop rod
Detail 2 Mount and align the roll-supporting arm as
per the counter-vise table.
2.7 Deactivation of machine
- If the sawing machine is to be out of use for a long
period, it is advisable to proceed as follows:
1) Detach the plug from the electric supply panel
2) Loosen blade
3) Release the saw arm return spring
4) Empty the coolant tank
5) Carefully clean and grease the machine
6) If necessary, cover the machine.
2.8 Dismantling (due to deterioration and/or
obsolescence)
General rules
If the machine is to be permanently demolished
and/or scrapped, divide the material to be disposed
of according to type and composition, as follows:
1) Cast iron or ferrous materials, composed of
metal alone, are secondary raw materials, so they
may be taken to an iron foundry for re-smelting after
having removed the contents (classified in point 3).
2) Electrical components, including the cable and
electronic material (magnetic cards, etc.), fall within
the category of material classified as being
assimilated to urban waste according to the laws of
your local, state, or federal government, so they
may be set aside for collection by the public waste
disposal service;
3) Old mineral and synthetic and/or mixed oils,
emulsified oils and greases are considered
hazardous or special refuse, so they must be
collected, transported and disposed of at a special
waste disposal service.
NOTE: The standards and legislation concerning
refuse is in a constant state of evolution, therefore
is subject to changes. The user must keep
informed of the regulations at the time of disposal
as these may differ from those described above.
3 THE MACHINE'S FUNCTIONAL
PARTS
3.1 The saw arm
Machine parts consisting of drive members (gear
motor or variable speed motor, flywheels), tension
and guides (blade guide slide, blade guide blocks)
of blade.
- 3 -
Advertisement
Table of Contents
