Table of Contents
Advertisement
Available languages
Available languages
3.2 Control Panel
A
1
B
13
12
16
14
17
A~K Control Switches
A.
Blade speed display
A1
Bow down flow regulator
B.
Main connect switch
C.
Saw bow up switch
D.
Saw bow down switch
E.
Hand/foot pedal operation selector
F.
Cycle start switch
G.
Hydraulic Start switch
H.
Emergency button
I.
Footpad emergency button
J.
Footpad switch
K.
Blade speed adjusting kno
A1
H
K
2
3
4
5
C
D
E
7
6
G
F
11
10
8
9
15
I
b
J
1~17 Indicator lights
Red- Warning indicator
Yellow- Selection indicator
Green- Operation indicator
1.
Power supply ON, indicator lights
2.
Saw bow up, indicator light
3.
Saw bow down, indicator light
4.
Hand operation, indicator light
5.
Foot pedal operation, indicator light
6.
Cycle start switch indicator light
7.
Start switch (hydraulic flow control), indicator
light
8.
Saw bow maximum height, indicator light
9.
Saw bow lowest height, indicator light
10. Open blade cover, warning indicator light
11.
Improper speed selection, warning indicator
light
12. Motor overload, warning indicator light
13. Broken blade, warning indicator light
14. Emergency button indicator light
15. Hydraulic motor overload, warning indicator
light
16. Foot pad's emergency button indicator light
17. Foot pad, operation indicator light
3.3 Vise adjustment
Clamping the Work Piece
- Place work piece between the jaws.
- Use the hand wheel to close the vise jaw. For
multiple cuts of a same size material, leave a small
gap between the work piece and vise jaw. Push
cycle start button (F). The vise will automatically
clamp the work piece while going through the
operation cycle. When the operation cycle is
finished, the vise will open and the work piece can
be adjusted or replaced.
Operation of the Vise
1
- 4 -
Advertisement
Table of Contents
