Machine Dimension; Getting To Know Your Machine - Promac SY-315 Manual

4. Machine dimensions, Transport, Installation and
Dismantling
4.1 Machine dimensions
4.2 Transporting the machine
When transporting in its own packaging, use a forklift
truck or hand trolley.
4.3 Minimum requirements for housing the machine
- The main voltage and frequency complying with the
requirements for the machine's motor.
- Environment temperature from –10°C to +50°C.
- Relative humidity not over 90%.
4.4 Information on fitting loose parts and accessories
Fit delivered parts
Fit the stop
Fit the wheel supports and align with the vice table.
4.5 Deactivating the machine
If the machine is to be inactive for a long period, prepare
the machine as follows:
1). Detach the plug from the electric supply panel
SY-315 / SY-315L
2). Release the saw blade
3). Release the head return spring
4). Empty the coolant tank
5). Carefully clean and grease the machine
6). If necessary, cover the machine.
4.6 Dismantling
General rules:
Before disposing of the machine, the machine should be
broken down and separated into the 3 categories as follows:
1) Cast iron or ferrous materials: These materials should be
of single composition, without combination or attachment to
other types of materials. This is a recyclable material. The
materials may be sent to metal scrap and recycling centers.
2) Electrical components: This includes cables and
electronic parts (magnetic cards, etc.). These materials may
be considered as urban waste. Give the materials to your
local public waste disposal service.
3) Old mineral, synthetic and/or mixed oils: Blend oils and
greases are special refuse. Have these collected by a
service specializing in oil disposal.
NOTE:
Standards and legislation for waste disposal is in a state
continuous change and evolution. The user must be
informed of current regulation for waste disposal of machine
tools, as they may differ from those described above. They
are to be considered as general guideline.

5. Getting to know your machine

5.1 Disk head assembly
Machine part composed of the parts that transmit movement
(motor, reduction unit), the lubricating coolant pump and the
electrical components.
A: Control Lever
A long angled lever with a handle grip and trigger switch for
starting, raising, and lowering the disk head
B: Transfer Case
The central part of the assembly, housing the gear system
and oil tank.
5