To set up the controller through the Service Port
Using a computer and an Ethernet cable, you can communicate with the TV-MPCXP1628-NR through a web
browser to:
•
View the controller's Module Status report
•
View/change controller and network settings. Changes take effect immediately.
•
Troubleshoot
•
Use BACnet/IP Service Port to access the i-Vu® application or a touchscreen device. See To communicate
through the BACnet/IP Service Port network (page 65).
Connect an Ethernet cable from a computer to the controller's Service Port, as shown below.
1
NOTE Be sure NOT to plug the cable into the Gig-E Port.
TruVu™ MPC Controller (part no. TV-MPCXP1628-NR)
Installation and Start-up Guide
To set up the controller through the Service Port
61
CARRIER CORPORATION ©2021
All rights reserved