Removing Jammed Media - Toshiba B-EX4T2 Series Manual

5.TROIBLESHOOTING
5.3 Removing Jammed
Media
CAUTION!
Do not use any tool that may
damage the Print Head.
NOTE:
If you get frequent jams in the
cutter, contact a TOSHIBA TEC
authorised service epresentative.
This section describes, in detail, how to remove jammed media from the
printer.
1. Turn off and unplug the printer.
2. Open the Top Cover.
3. Turn the Head Lever to FREE position, then open the Ribbon
Shaft Holder Plate.
4. Open the Print Head Block.
5. Remove the ribbon and media.
Print Head Block
6. Remove the jammed media from the printer. DO NOT use any
sharp implements or tools as these could damage the printer.
7. Clean the Print Head and Platen, then remove any further dust or
foreign substances.
8. Paper jams in the Cutter Unit can be caused by wear or residual
glue from label stock on the cutter. Do not use non-specified
media in the cutter.
When removing the jammed media, be careful not to damage the print head
with hard objects like watches or rings.
Care must be taken not to allow
the metal or glass part of a watch
to touch the print head.
Since the print head element can be easily damaged by shock, please treat it
carefully and do not hit it with hard objects.
43
Ribbon Shaft Holder Plate
CAUTION!
Care must be taken not to allow a
metal object like a ring to touch
the print head.