Table of Contents
Advertisement
3 Weld Editor Interface
3.5 Heat
3.5 Heat
Overview
Tap the Heat tab to view or modify heat phase parameters.
The heat phase parameters can only be modified in manual mode.
To copy the current weld phase mode settings, toggle Use Weld Phase Mode
off, on, and then off again.
Activation/deactivation of Heat
The Heat tab is only shown if Heat is active. It is active if the system parameter
Heat on (topic PROC, type Miller Arc Equipment Properties) is set to True.
Interface
xx1500000852
Button
Refresh
Confirm
Cancel
Continues on next page
42
Note
Tip
Description
The blue refresh button is used to return to the Weld Phase tab.
The green check button is used to confirm any changes made.
The red cancel button is used to cancel any changes made and re-
turn to the previous values.
Application manual - Miller Ethernet I/P Interface and Weld Editor
© Copyright 2015 ABB. All rights reserved.
3HAC054885-001 Revision: -
Advertisement
Table of Contents
