Setup Miller Ethernet/Ip Address In Miller Auto-Axcess - ABB RobotWare 6.02 Applications Manual

2.3.2 Setup Miller Ethernet/IP address in Miller Auto-Axcess

Prerequisites
Use one of the following web browsers:
Procedure
Application manual - Miller Ethernet I/P Interface and Weld Editor
3HAC054885-001 Revision: -
2.3.2 Setup Miller Ethernet/IP address in Miller Auto-Axcess
• Internet Explorer version 7 and higher
• Mozilla FireFox version 3 and higher
• Google Chrome version 15 and higher
• Safari version 5.1 and higher
• Opera version 11.5 and higher
1 Connect an Ethernet cable between your PC and the Ethernet Port A on the
Miller Axcess E welder.
Note
It may take up to 1 minute for the PC to acquire an IP address. If the PC is
set up with a static IP address it must either be changed to DHCP or
assigned an address in the range of Port A.
2 Open a web browser, enter 169.254.0.2 in the address bar and press the
Enter key on the keyboard.
3 Click the Login button on the Miller web page.
xx1500000815
© Copyright 2015 ABB. All rights reserved.
2 Installation and setup
Continues on next page
29