Table of Contents
Advertisement
A
WARNING
■
Read the entire manual as well as the decals on
the attachment (see Safety Section), before
attempting any maintenance, service, repair, or set-
up of the unit.
Although the attachment is supplied fully assembled,
some simple checks should be performed before oper-
ation begins.
SAFETY DECALS
The safety decals on the attachment should be clearly
readable and always followed. The location and
description of the decals is shown in the parts diagram.
Copies of the decals are shown in Safety Decals sec-
tion.
LUBRICATION
All attachment wheels, the sideshift bars and pivot
points shown in the parts diagram, should be greased
after 40 hours. All bearings should be greased with a
high temperature bearing grease after 40 hours of use.
Planetary gear lubrication should be changed with
EP90 gear lubrication after the first 50 hours of use and
every 500 hours of operation thereafter.
10 Set-Up
SET-UP INSTRUCTIONS
DRUM ASSEMBLY
For proper operation, all picks or teeth must be
installed in holders. Inspect picks every 4 hours of
operation. If any picks show excessive wear (carbide
tip missing / damaged or pick body worn), replace all
worn picks.
HOSES / FITTINGS
Hydraulic fittings are used to connect all attachment
hoses. All fittings should be tight and free of hydraulic
leaks. Hoses must be free of crimps or cuts that might
result in leakage. Check your attachment before opera-
tion to make sure all hose routing are kink-free and
allow for maximum movement of all sideshift, lift /
lower, and / or swing motion required during normal
operation.
RETAINING RINGS
The sideshift cylinder as mounted for operation is
retained with three 1" external retaining rings; four in
each depth cylinder and two on the tilt cylinder.
NOTICE
The planer should not be operated at any time
■
when any of these rings are damaged or missing.
MCP40S/C (Rev. 4/20/2007)
Advertisement
Table of Contents
