Operation 11 - Woods Alitec CP40S Operator's Manual

WARNING
 Safety instructions are important! Read all
attachment and power unit manuals; follow all
safety rules and safety decal information. (Replace-
ment manuals and safety decals are available from
your dealer.) Failure to follow instructions or safety
rules can result in serious injury or death.
 Power unit must be equipped with ROPS and
seat belt/operator restraint. Keep seat belt/operator
restraint securely fastened/engaged. Falling off
power unit can result in death from being run over
or crushed. Keep ROPS systems in place at all
times.
 Operators must be instructed in and be capable
of the safe operation of the equipment, its attach-
ments, and all controls. Do not allow anyone to
operate this equipment without proper instructions.
NOTICE
■ Skid steers must be equipped with an auxil-
iary hydraulic system capable of supplying contin-
uous flow for hydraulic motor operation.
SAFETY PRECAUTIONS
A careful operator is the best protection against acci-
dents. Most accidents involving operators of industrial
equipment are caused by failure to observe basic
safety precautions. Familiarize yourself with the safety
precautions listed below.
A
WARNING
The following precautions must be observed
■
for the safety of the operator and/or service per-
sonnel.
1. Read and observe all safety information and
decals on the skid steer loader and attachment
before operating the unit (see Safety Decals
section). In addition, familiarize yourself with all
loader safety devices and check daily that they are
functioning properly.
2. Refer to the safety section of your skid loader
operator's manual
recommendations set forth in that manual.
3. Never raise the attachment more than 24" off the
ground. When loading, keep attachment as low to
the ramps and trailer as possible.
MCP40S/C (Rev. 4/20/2007)
OPERATION
and observe all safety
4. Always lower the loader arms fully before leaving
the skid steer seat.
A
WARNING
Never crawl under raised loader arms.
■
5. Be sure to raise the attachment totally off the
ground before sideshifting.
6. Carefully inspect
connections on a routine basis. Always use a piece
of cardboard when searching for leaks.
7. Be sure to exercise the Mandatory Safety
Shutdown Procedure, see Service Section, page
14, before proceeding with any work on the
attachment.
A
WARNING
■ Never use your hands as escaping fluid under
pressure can penetrate the skin causing serious
injury. If hydraulic fluid does penetrate the skin,
seek immediate medical attention by a doctor
familiar with this type of injury of gangrene may
result.
■ Never allow hands or feet near any working
part of attachment unless the mandatory Safety
Shutdown Procedure has been completed.
PLANER OPERATION
The planer attachment is hydraulically powered and
intended for use in milling asphalt or concrete surfaces.
The performance of the attachment can vary greatly
depending upon how it is used and operated. There-
fore, the recommended operating procedures con-
tained within this manual should be followed at all times
for maximum productivity.
The attachment requires a minimum hydraulic supply
of 25 gallons per minute (90 liters per minute) at 2000
psi.
NOTICE
Insufficient hydraulic power will result in poor
■
performance.
In attaching the planer to the skid steer, ensure that all
three hydraulic hoses are coupled securely to the quick
couplers.

Operation 11

all hydraulic hoses and