Table of Contents
Advertisement
CLEANING
After Each Use
●
Remove large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
Inspect machine and replace worn or damaged
●
parts.
Replace any safety decals that are missing or not
●
readable.
Periodically or Before Extended Storage
●
Clean large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
Remove the remainder using a low-pressure water
●
spray.
PROBLEM
Planer loses power.
Tilt function is jumpy and
erratic.
Planer drive motor leaks
at shaft seal.
No functions work.
One function doesn't
work.
Bearing failure of motor
or output bearing.
MCP40S/C (Rev. 4/20/2007)
TROUBLESHOOTING
POSSIBLE CAUSES
Relief setting in hydraulic system lower
than standard 2000 psi or loader circuit
pump failure.
Tilt clamp bolts set too tight or rusted
plate.
Excess motor case drain pressure.
No power to controller.
Check power to coil.
Improper lubrication of bearing. Pick
holder replacement - welder not
grounded through drum.
1. Be careful when spraying near scratched or torn
safety decals or near edges of decals as water
spray can peel decal off surface.
2. Be careful when spraying near chipped or
scratched paint as water spray can lift paint.
3. If a pressure washer is used, follow the advice
of the pressure washer manufacturer.
Inspect machine and replace worn or damaged
●
parts.
Sand down scratches and the edges of areas of
●
missing paint and coat with Woods spray paint of
matching color (purchase from your Woods
dealer).
Replace any safety decals that are missing or not
●
readable (supplied free by your Woods dealer).
See Safety Decals section for location drawing.
CHECK THE FOLLOWING
Remove, clean or replace solenoid
cartridge or replace o-rings. Check
reliefs in the loader valve auxiliary
valve. Reset or replace any relief
below 2000 psi. The flow should be no
less than 25 gpm. If pump output is
20% less than rated pump specifica-
tion, the pump may require repair.
Consult loader service manual.
Loosen tilt clamp bolts to provide .015
clearance or grease between plates.
The maximum case drain pressure
allowed is 25 psi at full engine throttle.
Replace shaft seal.
Check fuse and power lead connec-
tions.
If coil has power and pulls, cartridge is
defective; replace cartridge. If coil
doesn't pull, check for power to coil or
replace coil.
Re-grease outboard bearing every 4-8
hours. During holder replacement,
ground welder directly to drum (see
Maintenance section).
Service 15
Advertisement
Table of Contents
