Table of Contents
Advertisement
DEALER SET-UP INSTRUCTIONS
Assembly of this cutter is the responsibility of the
WOODS dealer. It should be delivered to the owner
completely assembled, lubricated and adjusted for nor-
mal cutting conditions.
The cutter is shipped partially assembled. Assembly
will be easier if components are aligned and loosely
assembled before tightening hardware. Recommended
torque values for hardware are located on page 60.
Select a suitable working area. A smooth hard surface,
such as concrete, will make assembly much quicker.
Open parts boxes and lay out parts and hardware to
make location easy. Refer to illustrations, accompany-
ing text, parts lists and exploded view drawings.
Complete the check list on page 35 when assembly is
complete and cutter is delivered to the customer.
Before working underneath, carefully read Oper-
ator's Manual instructions, disconnect driveline,
raise mower, securely block up all corners with
jackstands, and check stability. Secure blocking
prevents equipment from dropping due to hydrau-
lic leak down, hydraulic system failures, or
mechanical component failures.
Do not disconnect hydraulic lines until machine
is securely blocked or placed in lowest position
and system pressure is released by operating
valve levers.
CAUTION
Always wear relatively tight and belted clothing
to avoid entanglement in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
(Rev. 5/29/2018)
MAN1237 (9/1/2017)
ASSEMBLY INSTRUCTIONS
ARNING
Small Aircraft Tires
Tongue at 11"
Tongue at 18"
Large Aircraft Tires
Tongue at 11"
Tongue at 18"
Remove Shipping Strap
1. Connect height control cylinder hose to tractor.
2. Connect wing control cylinder hoses to tractor.
3. Extend wing cylinders to bring wings to the wing
stops.
4. Extend height control cylinder to maximum height.
5. Pull inward on wing tail wheel arm and carefully
remove shipping strap.
Install Wheel
Figure 22. Center Section Wheel and
Hub Installation
Assembly 33
Attitude Rod Length
Beyond Nuts (34)
3.5
1.75
4.5
2.5
1. Center Wheel Yoke Arm
83. 1/2" NC x 3" HHCS GR5
88. 1/2" NC Flange Lock Nut
Advertisement
Table of Contents
