Test The Module - Rockwell Automation Allen-Bradley ControlLogix 1756-MVI Installation Instructions Manual

18 ControlLogix Multi-Vendor Interface Module
IMPORTANT
Note that if "Console on Port 1" is Enabled and "Console Baud
Rate" is 19200 baud, the module acts the same as if the Setup
jumper is in place.
5. If a Compact Flash card has been installed, change the
"Compact Flash" setting to Enabled. The Compact Flash card
will act as drive C:\.
6. Press Esc to exit the Setup Menu.

Test the Module

The module should boot to the DOS command prompt, A>. Type
"dir" to display the contents of the ROM disk.
Publication 1756-IN001A-US-P - May 2000
The configuration set with the MVI Module
Configuration Menu is enabled only when the
Setup jumper is not installed. If the Setup
jumper is installed, the MVI console port is
configured at 19200 baud, no parity, 8 data bits,
and 1 stop bit.