Heatscope PURE Original Installation And Instruction Manual page 29

OPERATION, INSTALLATION INSTRUCTIONS AND MIN. DISTANCES
Once you have installed the unit, you can use it for the first time.
®
The HEATSCOPE features two omnipolar „ON/OFF" switches. You can control the radiant heater manually using these
selector switches on the unit itself.
The unit must be connected to a residual current circuit breaker and a fuse! Install the unit in any indoor or outdoor
areas. The heater is IP65 protected from water jets and dust.
CAUTION: The mounting of the heater on the wall and on the cieling as well as in glass houses and conservatories has
professionally to be accomplished solely according to the mounting regulations. Specified safety distances given are
min. values and may deviate from the local building and fire safety regulations. The safety distances as well as the local
building and fire safety regulations must be complied with at all times, leave inproper stated installation settings undone
at any time. Deviant installation settings require the technical approval of the manufacturer. In the case of a deviant
installation setting without approval of the manufacturer danger for people and environment may occur. Warranty and
guarantee expires for all heaters, which are not installed according to this operation and installation manual!
Other protective spacings may need to be taken in accordance with local fire safety regulations, e.g. for installation on
cumbustible surfaces.
All cables must be positioned so that they cannot come into contact with the surface of the radiant heater at any time.
®
The radiant heater must not be installed directly below a power socket. The sides of the HEATSCOPE must be at least
20 cm from any power sockets.
29
EN
EN
29