Table of Contents
Advertisement
of the devices therefore depends on the port order
and not on the USB jack used. After restarting the
receiver,
the numbering of the devices may change.
We therefore recommend to connect only one USB
storage device for timer recordings.
page
33 (recording device) and
player).
Installation
In the case of First commissioning of the receiver Appears on
the TV-screen the XORO Installations menü*. this menu
comprises following options:
1.
OSD language
2.
Land
3.
Sendersuche
4.
Pre-prog. Load list
You can use the arrow keys to switch between the four menu items. If the menu item is colored,
you can customize it with the keys .
OSD Language
Select the language in which the screen menus are displayed .
Land
Select the country in which you operate the receiver.
Settings
Customers,to which the
"SenderSearch/Satellite Setting" and perform a search:
•
Customers with rotatable satellite antennas (motor)
•
Customers with multiple satellite antennas or LNB (DiSEqC)
•
Customers with non-standard receiving components
Most customers can use the installation at this point with the selection "Pre prog. Load List"
Complete.
Pre-prog. Load List (LoadPre-programmed List) - Recommended
In the software of the Recveivers a list of stations for the satellite ASTRA 19.2° is stored ex
works. In this list the German TV channels are stored on the front program numbers.
cases, the installation of the receiver is complete with the loading of the sender list. If you
have a "Unicable"
programmed list. Please refer to the following pages.
If necessary,adjust . OSD language and country and
programmed sat list. Press ok to confirm your selection.
of 16
following
applies,
receiver, you have to make the Unicable settings after loading the pre-
Please also note
page
22 (media
can
access advanced
decide if
settings via the menu
In most
you want to use the pre-
Advertisement
Table of Contents
