First Time Installation; Channel Search - Xoro HRT 7622 User Manual

First Time Installation

• Connect the Receiver to your TV and your Antenna.
• Connect the Receiver to a Mains Socket
• Power On your TV and select the correct signal source (HDMI or SCART) with the Remote Con-
troller of your TV. Please consult the User Manual of your TV.
• Once the receiver is powered the booting up process
takes 15-20 seconds.
If everything is connected properly, you will see the Instal-
lation Guide on the TV screen.
Use the arrow keys ▲/▼ to navigate among menu items.
If a menu item is highlighted you can use the ◄/► keys to
make changes.
OSD Language
Set the OSD language.
Country
Select the country in which the receiver is to be operated.
Antenna Power
In case your antenna needs to be supplied with power (e.g. an indoor antenna with an amplifier but no
power supply unit) by your receiver you need to activate this function in the menu.
LCN
Turn LCN on if you want to use the Channel Numbering Scheme defined by your DVB-T/T2 operator.
Please note the capabilities to edit the channel list are limited if LCN is enabled. It is possible to turn
LCN off/on in Program Menu after the first time installation.

Channel Search

Initiate the Channel Scan by pressing OK. It can take a
couple of minutes to complete the scan.
In case not all channels appear in the list after the scan you
need to readjust the antenna or use a more powerful anten-
na and repeat the scan mode.
Note:
• There are no Radio Channels available in certain countries.
• LCN is not supported in certain countries.
• After moving to another region you have to repeat the channel scan.
ENG 7