Table of Contents
Advertisement
DiSEqC 1.0/11
:
Motor:
Antenna and search - procedure
On the left side of the on-screen menu, you can see
a list of satellites for which the receiver pre-orders
lists
On the right, you can see the settings for
satellite , which you are working on the left side of the
Have chosen.
Antenna and search - procedure
•
Use
the buttons to select the first satellite you want toset up.
•
Press ok . A hook appears in front of the selected satellite. The hook causes the satellite
to be taken into account in the following transmitter search.
•
Press the arrow key to switch to the right side.
•
You can use the keys to select the different settings, and use the keys to change
them.
•
If you have adjusted all the settings for the satellite, press the MENU button to switch back
to the left side.
If you can receive several satellites with your receiving system, now select another satellite
with the buttons, press the OK button
the right.
•
Repeat the steps for all satellites that you can receive with your antenna system.
Notes:
•
in Lower Part of the menus becomes, after the settings for the Selected satellites correct
executed Were the Approximate values for the Signal is displayed.
•
If a satellite is missing from the list, you can press the RED button ADD
A window opens, enter the longitude,East/West, and band values. Give the new satellite
a name. If you add a new satellite, the search mode "BlindSearch" must be used for the
following channel search. When you add a satellite to the
correct settings, no signal quality is displayed. This display is only available for satellites
for which a transponder list has been stored.
Initial
No
No
for this one as well, and then make the settings on
list, you may see. despite
of 19
Advertisement
Table of Contents
