Table of Contents
Advertisement
•
With the Taste GOTO you display the transponders stored for the selected satellite.
RED button allows you to
transponders for a
Antenna and search - explanation
LNB Type
Select
which
oscillator frequency your LNB
uses. The correct value can be
manual of your LNB. (Default: 09750/10750)
If
you
have
a
receiver, please choose the LNB type Unicable
(A or B, for a Unicable system for receiving a
satellite A is usually the right choice). Now select
a
free
user band and
Please refer to the instructions for your Unicable recommendation system for details. Ask
landlord about the free user tape when the connection is provided in a rental apartment. The
settings "LOF Lowband"and "LOW Highband" need to be changed very rarely and should always
be left at 09750 und10600 .
LNB Supply
The setting determines with which voltage the antenna system is supplied. The level of voltage
also determines whether horizontally or vertically polarized transponders are received. This
setting must only be changed in very rare cases. An incorrect setting causes senders to be
missing or no reception
22KHz
By switching on a 22KHz signal, the receiver can switch the LNB for receiving another frequency
band. This setting only needs to be changed in very rare cases. An incorrect setting causes
senders to be missing or no reception
Toneburst
Toneburst switches have two inputs,
receiver. If you
have such
B)the satellite selected on the left is connected.
of 20
Initial
add new transponders. The
search.
of the
parameters
found in the
Unicable/SCR
EN50494
its
band frequency.
possible. (Standard: 13/18V)
possible. (Standard: Auto)
allowing you to connect two antennas or LNB to the
a
switch, you must choose to which of the connections (A or
OK button is used to select
The
your
Advertisement
Table of Contents
