Volkswagen Elli Charger Manual page 29

3. Install and connect charging cable.
WARNING
An incorrect routing of the wires of the charging cable will result in improper installation,
which can cause a malfunction of the safety features of the wallbox.
— Do not route the PE and CP wires of the charging cable through the ELS sensor.
— Route only the blue (N), brown (L1) (as well as black (L2) and grey (L3) for

3-phase version) wires through the ELS sensor.
CAUTION
An incorrect mounting of the charging cable holder in the main assembly may result
in improper installation, which can cause damage to wallbox components.
— Make sure that the charging cable is positioned with the V-shaped side

towards the main assembly.

a. Place the charging cable holder on the main assembly with the V-shaped side

towards the main assembly.

b. Connect the PE wire of the charging cable to the second available slot

of the PE feed-through terminal.

c. Connect the CP wire of the charging cable to the CP feed-through terminal,

located at the end of the DIN-rail.

d. Route Neutral (N), L1 (as well as L2 and L3 - for 3-phase version) wire(s)

of the charging cable through the ELS sensor. Connect them directly to the
terminals on the power board according to the table below.
Wires
Color Brown
4. Set the DIP-switches.
CAUTION
A damaged communication board may result in improper installation and thus cause
unstable wallbox functionality.
— Be careful not to damage the communication board during DIP-switches configuration.

See chapter Set DIP-switches for the DIP-switch settings required.
5. Remove cardboard cover.
Color coding for EV charging cable
L1 L2
Black
L3 N
Grey Blue
PE
Green / Yellow
Elli Charger 27
EN