Maytronics OzoneSwim 1200i User Manual page 6

1000, 2000, 3000 control units
These products must be installed by a qualified installer
MEDIA FILTER
from
PUMP
pool
Note: If this system is installed below water level, ensure you have a
drain valve fitted to the ozone outlet.
Step 1:
Mount Ozone Swim control unit a maximum of 1.5 meters from the filter
and chlorine cell. Fit two screws 380mm apart (screws supplied for control
unit). Install the Ozone Swim control unit a minimum of 900mm above
ground level in an area protected from the elements to eliminate possible
damage from severe weather conditions. (If system is below water level,
install drain valve as per instructions).
Step 2:
Plumb chlorine cell onto return pipe after filter, ensuring there is a gas trap
(see images below).
Step 3:
Plumb Ozone injector manifold after chlorine cell on the return of the
pool ensuring the direction of the ozone injector manifold is correct. The
manifold should be the last on the return line, after all other equipment is
installed.
1 0
CONTROL UNIT
CHLORINATOR
CELL
INJECTION
MANIFOLD
return
to pool
Step 4:
Connect the chlorine cell cable to the three colour coded terminals located
on chlorine cell. (Terminals need to be slightly crimped for snug fit).
Step 5:
Ensure appropriate salt/mineral levels are achieved (3500 - 4500ppm) and
dissolved. (Confirm with builder/supplier that chemicals can be added to
the pool).
Step 6:
Leave plumbing to cure for a 24-hour period for best results.
Step 7:
Set timer on Ozone Swim system to recommended run time for pool size
and environment (refer to page 16).
Step 8:
Plug pump power cable into Ozone Swim unit below timer. Turn unit ON to
manual. Ozone light should be on. Check all plumbing for visible leaks.
Step 9:
Adjust the Chlorine cell output to recommended output.
Note: We recommend running your system at maximum output for the
first week of operation.
Step 10:
Set the sanitation switch to the Auto position.
U s e r M a n U a l 1 1