2.1.3
For Studio 260 / 360:
1.
Turn countersunk brass screws (A) into music desk slat (B) by hand till screws
stick out 2 mm (C).
2.
Place music desk at the right position, with screw points into the pre-drilled
holes (D).
3.
Tighten screws of the music desk with a screw driver. The use of an electric
screw driver is not recommended.
4.
Remove green protection foils (E) from plexiglas part of the music desk.
2.1.4
Installation pedal board
1.
Shift pedal board against black
pedal front cover (A). Pedal bolts
(B) will stick out 5 mm.
2.
For security reasons mount
pedal board to organ with wing
nuts (C).
User Manual Studio 260 / 360 / P-360
Installation music desk
14