Table of Contents
Advertisement
7.0 Fault Finding / Maintenance
7.1 Fault Finding
If the hoist will not operate:-
ENSURE THE BATTERY IS CHARGED AND THAT IT IS
•
ATTACHED CORRECTLY TO THE CONTROL BOX
ENSURE THAT STOP BUTTON IS IN THE OUT POSITION.
•
MAKE SURE THE CHARGING LEAD IS DISCONECTED FROM
•
THE MAINS POWER SUPPLY
CHECK THE HANDSET LEAD HAS NOT BEEN PULLED
•
FROM THE CONTROL BOX SOCKET OR WIRES DAMAGED
If the above checks prove unsuccessful, contact the service department
of your nearest FREEWAY APPROVED AGENT
7.2 Service / Maintenance
Any works performed on the SA-160 must be in accordance with the
specifications detailed in the test requirements of BS 10535:2006.
You should also consider if the hoist requires servicing in accordance
with "LOLER REGULATIONS" (Lifting Operations and Lifting Equipment
Regulations 1998).
7.3 Cleaning, Disinfection and Sterilisation
The SA-160 has an anti-microbial coating. This does not replace the
need to clean and maintain the hoist unit.
Routine cleaning: the exterior of the hoist can be wiped over with
•
a damp cloth containing a mild soap solution.
Disinfection and Sterilisation: the exterior of the hoist should on-
•
ly be, disinfected and sterilised using Isopropyl alcohol. Dampen a
cloth with isopropyl alcohol and wipe down the entire exterior of hoist.
DO NOT USE ABRASIVE MATERIALS
DO NOT IMMERSE THE HOIST UNIT.
SA160 User Manual
Rev 5—October 2016
Page 18
Advertisement
Table of Contents
