Prism Medical UK FREEWAY SA160 User Manual page 26

How to fit the Standing Support Sling
Note: The person to be transferred shall be referred to as "the person".
Ensure the label and grab handles are facing away from the person before
commencing the fitting procedure below.
1
Place the sling down the back to a position
just beneath the shoulder blades and above
the belt line. If the sling can not be
Introduced from behind, apply the sling in a
position level with the person.
3
Place the person's feet on to the foot plate
and adjust the knee pad (the knee pad should
be positioned at the top of the shin avoiding
the knee joint) the two straps should now be
attached to the carry bar hooks. Raise the
carry bar just enough to tension the straps
and ensure that they are still securely
attached. As the person is about to be lift-
ed check the chest strap for tension and com-
fort. Re-adjust when required.
To remove the sling, carry out the fitting procedure in reverse.
Important - always peel the sling away from the person to avoid skin friction and movement.
The above & following techniques are for guidance only and you must comply with your local policies
If in doubt, consult your moving and handling advisor
SA160 User Manual
Bring the two sections of the chest strap
around the person's chest and fasten
securely using the hook & loop and buckle
fastening. Note: the chest strap is purely
intended for the security of the person and is
not weight bearing.
Alternatively you can attach the sling to the
lower sling hooks, this will facilitate an
alternative standing procedure.
Important - always re-assess for client's
co-operation and capability when using this
sling.
Notes
Rev 5—October 2016
2
4
Page 26