Table of Contents
Advertisement
Using the Posterior Sling in conjunction with the Standing
The posterior straps must first be attached to the Freeway SA–160 by following the
diagrams below:
1
1.
Thread loop of posterior strap under lower bar.
2.
Thread hook through the end of the loop and pull through to form attachment to lower
bar.
3.
Thread hook end of the strap to the inside of the top bar and thread through the metal
loop on the boom of the Freeway SA160.
4.
Adjust the length of the strap using the slider buckle to suit the individual.
1
1.
Fit the Standing support strap as described on the previous page (Items 1 & 2) and
then introduce the posterior sling level with the persons hips.
2.
Attach the posterior sling to the posterior straps.
3.
Introduce the Freeway SA-160 as described in the previous section (item 3).
Raise the carry bar just enough to tension the straps and ensure that they are still
securely attached and there is no twists in the posterior straps.
As you start the lifting procedure the posterior sling will support the majority of the lift,
(If NOT adjust the chest sling straps or the posterior straps placed at the bottom near
the hoist attachment bar as shown in item 4 above) as the standing continues the
chest sling will gradually take over, once in standing the posterior sling will be relaxed to
allow
access to clothing.
Only use the Standing Support sling & Posterior sling with clients with the ability to
stand.
Do not fix the posterior straps to anything other than the "D" rings on the posterior
SA160 User Manual
Support Sling
2
2
Rev 5—October 2016
3
3
4
Page 27
Advertisement
Table of Contents
