Configuring Interval Timer Settings; Using A Interval Timer For Elapsed Time Measurement; Checking The On/Off Status Of Programmable Timers - Casio 5641 Operation Manual

Configuring Interval Timer Settings

If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.
Using the Timer
l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
3.
Use (E) and (B) to specify the number of
timer repeats.
4.
Press (D).
5.
Use (E) and (B) to specify the position of
the timer in the sequence.
To specify the first position, set [1].
●
6.
Press (D).
This causes the cursor to appear at the
minutes setting of the first timer.
7.
Use (E) and (B) to change the minutes
setting.
Minutes
8.
Press (D).
This causes the cursor to move to the
seconds setting of the first timer.
Watch Operation Guide 5641
9.
Use (E) and (B) to change the seconds
setting.
10.
Press (D) twice.
This returns to the screen in step 5.
11.
Repeat steps 5 through 10 as many times
as necessary to configure the settings of
other timers.
12.
Press (A) to complete the setting
operation.
Note
You can also use G-SHOCK MOVE to
●
configure programmable timer
settings.
Using a Interval Timer for Elapsed
Time Measurement
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Press (E) to start the timer countdown.
The watch beeps every second for the last
five seconds of the current countdown,
and starts the countdown of the next timer
when the end is reached.
To pause an ongoing timer countdown,
●
press (E). You can reset a paused
countdown to its start time by pressing
(A).
When there is a multiple timer
●
countdown operation in progress, you
can terminate the current countdown
and start the next countdown by holding
down (A) for at least 0.5 seconds.
Seconds
Checking the On/Off Status of
Programmable Timers
In the Timer Mode, you can find out if each of
the programmable timers is turned on or off by
checking Graphic Indicator B.
The current status of a programmable timer is
indicated by whether the indicator segment of
the program number is displayed, flashing, or
not displayed.
Graphic Indicator B
Program 1
Program 2
Program 3
Program 4
Programmable timer status
Not programmed Not displayed
Programmed
Operation in progress/Auto
Start
Paused
Timer settings being
configured
* Segment disappears when the program is
complete.
Example Display
Program 1, 2, 4: Programmed
Program 3, 5: Not programmed
Program 2: Timer countdown operation in
progress
Timer countdown operation in progress
Not programmed
Programmed
Program 5
Graphic
Displayed
Flashing *
Flashing
19