Scrolling Between Life Log Screens; Resetting Life Log Measurements - Casio 5641 Operation Manual

Scrolling Between Life Log
Screens
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Press (C) to display the Life Log screen.
Day of the week, hour, minute, second, month, day
C
Life Log 3 (Step count) Life Log 1 (Distance)
Today's distance
Daily step count
C
Life Log 2 (Calories)
Today's calories
Watch Operation Guide 5641
Interpreting the Progress Graph
●
The progress graph shows the progress you
have made towards reaching the daily
distance, calorie, and step count target values
you specified. You can view your daily
progress for up to seven days.
Graph contents are normally refreshed
●
every minute.
Progress (%)
C
C
Checking Your Progress to Your Daily
●
Step Target
Graphic Indicator A shows the current percent
(%) of the preset target value that has been
reached.
Example: Daily target of 10,000 steps
Current
80‒
60‒
40‒
20‒
1‒
6 5 4 3 2 1
Today
7 days
0 steps (Progress: 0%)
1,000 steps (Progress: 10%)
5,000 steps (Progress: 50%)
10,000 steps (goal attained)
Note
Distance can be measured up to
●
9,999.99 km. The watch display will
continue to show 9,999.99 km even if
the actual distance becomes 10,000
km or greater.
Calories can be measured up to
●
99,999 kcal. The watch display will
continue to show 99,999 kcal even if
the actual calories burned becomes
100,000 kcal or greater.
The step count can show a value up to
●
999,999 steps. If the step count
exceeds 999,999, the maximum value
(999,999) remains on the display.
To avoid miscounting of non-walking
●
movements, the step count will not
start until after you have been walking
for about 20 seconds. The number of
steps you took during the first 20
seconds will be included in the total.
The step count is reset to zero at
●
midnight each day.
To save power, step counting stops
●
automatically if you take off the watch
(no detectable watch movement) and
you do not perform any operation for
two or three minutes.
Graph contents are updated even
●
when any one of the events below
occurs.
When accelerometer operation is
ー
stopped to save power
When counting is not possible due
ー
to accelerometer error or insufficient
power
Resetting Life Log
Measurements
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Use (C) to display the Life Log setting item
you want to reset.
3.
Hold down(C) and (E) for at least two
seconds.
This resets the measurement value.
Example: To reset the step count
13