Baumatic BTC2.1SSS User Manual page 23

o Apply the sealing strip provided around the edge of the
appliance.
o The protective covering must be removed from both sides.
o Do not leave a gap in the sealing agent or overlap the thickness.
o IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the aperture in future, particularly if it needs to be
serviced.
o Place the fixing brackets (B) over each hole and clip, and then
place a screw (C) through the hole and fixing bracket (B).
Tighten the screws a little way, so that they stay in place.
IMPORTANT: Do not tighten the screws fully.
o Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
(A) Clip
(B) Fixing bracket
(C) Screw
o You should insert a clip (A) into
the holes which are located in
each corner of the hob.
o On the underneath of the hob,
locate the fixing brackets (B) and
turn them so that they locate on
the underneath of the worktop
and the hob.
o Fully tighten the screws (C) to
secure the hob into position.
23