Electrical Connections - Hanseatic HGVI6082D127711DS User Manual

Page EN-30 Installation, fitting and connection
Ensure that the inlet hose is correctly
■
connected and is not kinked or
damaged.
3
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the union nut of the inlet hose to
the water tap until it is tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slowly
and ensure that no water is escaping.
3. Then close the tap again.
¾ inch
Inlet hose with
rubber seal

Electrical connections

WARNING!
Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
Prior to connecting the dishwasher,
■
ensure that you have page EN-5 tak-
en note of all the safety instructions
and adhered to them.
Fire hazard!
Never use multi-socket adapters,
■
multi-socket strips, travel adapters or
the like.
Depending on the recess into which the dish-
washer will be fitted, the dishwasher should
be connected before or after fitting.
– For the electrical connection of the dish-
washer, a professional must install an
earthed power socket with its own fuse of
a sufficient size (see „Technical specifica-
tions" on page EN-40).
– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.
– Do not use a multi-socket extension cable,
multi-socket plug, travel adapter, extension
cable or similar.
– We recommend using a pulse-sensitive re-
sidual current device (RCD).
• Insert the mains plug into the socket.