Connecting The Inlet Hose; Electrical Connections - Hanseatic HGU4582D97710DI User Manual

There is a washer in an unused exhaust
manifold that prevents water from es-
caping here. This washer must be re-
placed by a seal ring before connecting the
outlet hose.

Connecting the inlet hose

Risk of electric shock!
The inlet hose is equipped with an aqua
stop system which has an AC voltage of
230 V.
Do not cut through the inlet hose un-
■
der any circumstances if the mains
plug of the dishwasher is in the socket.
If the inlet hose is damaged, contact
our service team (see page EN-38).
NOTICE
Risk of damage!
The dishwasher is set up for a water
pressure of 0.4 bar to 10 bar (0.04 MPa
to 1.0 MPa). Water must always be
able to run freely into the dishwasher,
otherwise this can damage the
appliance.
For water pressure of less than 10
■
bar, install a pressure reducer (in case
of doubt, seek information from the
water supply company).
Never connect the appliance to the
■
water tap or the mixing arm of a
water heater (e.g. continuous fl ow
heater, pressure-free boiler etc.).
Ensure that the inlet hose is correctly
■
connected and is not kinked or
damaged.
3
Installation, fitting, connection
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the union nut of the inlet hose to
the water tap until it is tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slowly
and ensure that no water is escaping.
3. Then close the tap again.

Electrical connections

WARNING!
Electric shock / fi re hazard!
Prior to connecting the dishwasher,
■
ensure that you have page EN-4 taken
note of all the safety instructions and
adhered to them.
Depending on the recess into which the dish-
washer will be fitted, the dishwasher should
be connected before or after fitting.
– For the electrical connection of the dish-
washer, a professional must install an
earthed power socket with its own fuse of
a sufficient size (see "Technical specifica-
tions" on page EN-40).
– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.
– Do not use a multi-socket extension cable,
multi-socket plug, travel adapter, extension
cable or similar.
Page EN-29
¾ inch
Inlet hose with
rubber seal