Installed Layout - Qlogic InfiniPath Install Manual

3 – Software Installation
Downloading and Installing InfiniPath and OpenFabrics Software
node. After making sure the RPMs are on each node, login as root and, for the
InfiniPath and InfiniPath-MPI RPMs, run the command:
# rpm -Uvh InfiniPath/*.rpm InfiniPath-MPI/*.rpm \
InfiniPath-Devel/*.rpm
For the OpenFabrics RPMs run the command:
# rpm -Uvh OpenFabrics/*.rpm OpenFabrics-Devel/*.rpm
Parallel command starters can be used for installation on multiple nodes, but this
is beyond the scope of this documentation.
NOTE:
NOTE:
An alternate method to manage installation by using Rocks is given below in
section
3.5.3

Installed Layout

The default installed layout for the InfiniPath software is listed below.
The InfiniPath shared libraries are installed in:
/usr/lib for 32-bit applications
/usr/lib64 for 64-bit applications
MPI include files are in:
/usr/include
MPI programming examples and source for several MPI benchmarks are in:
/usr/share/mpich/examples
InfiniPath utility programs, as well as MPI utilities and benchmarks are installed in:
/usr/bin
The InfiniPath kernel modules are installed in the standard module locations in:
/lib/modules (version dependent)
Documentation can be found in:
3-8
Installation of the InfiniPath driver RPM
(infinipath-kernel-2.0-xxx-yyy) builds kernel modules for the
currently running kernel version. These InfiniPath modules will only work
with that kernel. If a different kernel is booted, the InfiniPath driver RPM
must be re-installed or rebuilt See
RPMs contain config files. Your current config files will not be
overwritten when new RPMs are installed. New config files will contain
the suffix .rpmnew and can be found in /etc/sysconfig. Check the
new file(s) to see if there is anything you want to add to your standard
config file.
3.6.
section 3.14 for more information.
Q
IB0056101-00 C