Infinipath Software Rpms; Openfabrics Rpms - Qlogic InfiniPath Install Manual

Q
3.3

InfiniPath Software RPMs

Linux distributions of InfiniPath software are installed from binary RPMs. RPM is a
Linux packaging and installation tool used by Red Hat, SUSE, and CentOS. Each
set of RPMs uses a build identifier
distribution identifiers are shown below with the associated operating systems.
Distribution
identifier
fc3
suse9.3
sles10
(for ppc64)
The individual RPMs are listed and described in Appendix A "RPM Descriptions".
To generate a list of InfiniPath software package contents on each RPM run:
$ rpm -qlp rpm_file_name
3.4

OpenFabrics RPMs

The OpenFabrics kernel module support is now part of the InfiniPath RPMs.
However, in order to use OpenFabrics, you need to install these user libraries,
utilities and other program RPMs.
Each set of the OpenFabrics RPMs uses a distribution identifier
for this release are fc4, suse9.3,and sles10. Note that these identifiers are
different than those for the InfiniPath RPMs.
The RPM distribution identifiers are shown below with the associated operating
systems.
Distribution
identifier
fc4
suse9.3
sles10
NOTE:
IB0056101-00 C
Table 3-2. InfiniPath RPMs to Use for Each Node in a Cluster
Fedora Core 3, Fedora Core 4, Red Hat Enterprise Linux 4 (rhel4),
CentOS 4.0-4.3 (Rocks 4.0-4.3) for x86_64 systems
SUSE 9.3, ,SLES 9, SLES 10 for x86_64 systems
SLES 10 for IBM Blade Center H (ppc64) systems only
Table 3-3. OpenFabrics RPMs to Use for Each Node in a Cluster
Fedora Core 4 x86_64 systems
SUSE 9.3, SLES 9, SLES 10 x86_64 systems
SLES 10 for IBM Blade Center H (ppc64) systems only
The earlier OpenIB for PathScale RPMs (Versions 0.1.0 and 0.2.0) for
the InfiniPath 1.1 and 1.2 releases are not compatible with this InfiniPath
Version 2.0 release. If you have installed these RPMs, you must remove
and a distribution identifier
xxx
Used on
Used on
3 – Software Installation

OpenFabrics RPMs

. The RPM
yyy
. The identifiers
yyy
3-5