Saving Test Results To A Test Record - Vanguard Instruments CVT-765 User Manual

3.6.2. Saving Test Results to a Test Record

After performing a test, the user is presented the option to save the test results to the unit's
Flash EEPROM or to a USB Flash Drive. If the test results are not saved immediately after
performing a test, they will still remain in the working memory and can be saved later, as long
as a new test has not been performed and the unit has not been turned off. Follow the steps
below to save the test results from the working memory to a test record (the following
procedure can also be used to re-save a restored test record to a new memory location or to a
USB Flash Drive):
a. Perform a test or restore a test record to the working memory (see section 3.6.3 and
3.6.4), and then start from the "START-UP" menu:
1. TEST TRANSFORMER
2. SETUP
TIME: 15:16:17
DATE: 05/17/11
[2]
Press the key (SETUP).
b. The following screen will be displayed:
1. RECORD ID
2. SET 50/60 HZ
3. DISPLAY RECORD
4. SAVE/RESTORE RECORD
5. SET TIME
6. set language
[4]
Press the key (SAVE/RESTORE RECORD).
CVT-765 USER'S MANUAL REV 1
21