Electrical; Installing A Shutter Barrel - ETC ColorSource Spot Installation Manual

ETC Installation Manual

Electrical

WARNING:
• Operates between 100V and 240VAC at a frequency of 50/60Hz.
• Maximum power consumption is 185W.
• Up to 9 luminaires (15A max) may be linked via power thru connector
(10 luminaires total per circuit) when used with an R20 relay module or
Unison Echo Relay Panel. Consult breaker trip curves when used with
other equipment. Requires power from a non-dimmable source.

Installing a shutter barrel

The ColorSouce Spot can
be purchased with or
without a shutter barrel.
To install a shutter barrel
you will need a #2 Phillips
Screwdriver. (not
provided)
The ColorSource light
engine includes a barrel
screw. The small screw
used to secure the top of
the shutter barrel is
included with the shutter
barrel.
Step 1:
Step 2:
Step 3:
Step 4:
ColorSource Spot
Disconnect the fixture from power and DMX and
allow it to cool before performing any cleaning and
maintenance.
Align the barrel to the front of the ColorSource Spot and
rotate it one quarter turn counter-clockwise
Insert the shutter barrel into the front of the light engine and
rotate clockwise until it is fully threaded onto the light engine.
Insert the barrel screw at the bottom of the light engine and
tighten.
Insert the small screw into the top of the light engine and
tighten using the Phillips screwdriver
Page 2 of 8
ColorSource Spot
Small screw included with the
shutter barrel
ColorSource Spot
light engine
Electronic Theatre Controls, Inc.